How to Clean Your Cube

These are instructions on how to clean you rubik's cube. This guide will disassemble, asseble, clean, and lube your cube. You should follow these steps if your cube is starting to feel a bit rough or white things are appearing inside your cube.

Ingredients

• Cloth
• Toothbrush (do NOT use it again after cleaning your cube).
• Lube (personally, I use weight 1 together with lunar. The higher the weight, your cube will feel more heavy and rough after lubing).
• Clean surface for you to work on.

Directions

1. First, take disassemble your cube by taking about the edge piece.
2. Then, take the other pieces out using your fingers.
3. After, use your toothbrush to clean each individual peices.
4. After that, use your cloth to clean the individual peices (The cloth will take away any leftover hair from the toothbrush).
5. Then, asseble your cube back except for one corner and edge peice. You can do this by first putting the bottom four edge peices. Then, put the bottom four corner peices using the help of the edge peices. After that, put the 4 middle edge peices. After doing that, you can make the laster layer in corner, edge pattern.
6. With the last two peices, put your lube on the parts that has contact with other peices.
7. Put the last two peices into the cube.
8. After, break the lube in (By that, I mean to do lots of solves so that the lube will spread out on the cube and all peices will feel lubes and feel the same)
9. Then, you can drop your 2nd lube and break it in.

Now your done!